产地。 | 中国浙江 | Rated Voltage: | AC(50-60hz)110-220V |
品牌名称: | 敏捷/RHT | 额定功率: | 30W |
型号。 | EC-506 | 电台 频率。 | 8.2Mhz/10.2Mhz |
产品名称。 | EAS RF System | 检测宽度: | 110~240CM (Depend on tag) |
颜色。 | 黑色 | 天线材料: | Aluminem Alloy |
尺寸。 | 1580*380*30mm | 工作条件: | -20℃-45℃ |
工作模式: | TX+RX | 认证。 | 剑桥大学 |
包装和交付
销售单位。单一项目
Single package size: 161x42x19 cm
Single gross weight: 15.000 kg
包装类型。
Packing Size: 1560*450*150mm
Packing Unit: 2pcs/ctn
Packing G.W.: 14.5kgs/ctn
数量(件) | 1 - 50 | >50 |
估计数。时间(天) | 15 | 有待商榷 |
产品介绍
种类 EAS天线
收发器EAS天线
收发器EAS天线是单一的天线,既是磁场输入的创造者,又是磁场输入的接收器。使用收发器天线的EAS系统是最便宜的系统。它们的广播高度通常为一米(有效长度为39英寸,一个单元可以覆盖一个典型的门。两台设备可以很容易地保护一扇双门,如果间隔适当,两台设备也可以覆盖商场环境中4米的开口。由于这些设备可以广播和接收,它们通常在所有方向上广播和接收,因此,有标记或有标签的商品不能放在离Insta内置天线太近的地方。射频和调幅EAS系统都可以使用收发器天线。这些是目前市场上最流行的设备,有各种形状,包括流行的INEO透明丙烯酸系统,看起来非常现代和优雅。
多天线EAS系统
最常见的多天线EAS系统的形式是单通道双天线EAS系统,即用一个以上的天线来形成通往商店入口的通道。其中一个天线是发射器,另一个是接收器。天线在它们之间产生一个低频无线电波场,这样,贴有标签的商品就会通过这个场,天线就会感应到商品上的标签或标识并发出警报。
单通道双天线系统用于商店门口超过一米(36英寸),因此太宽而无法使用EAS收发器系统的情况。由于无线电波场的焦点在天线之间,这种类型的EAS系统允许在2米(72英寸)内放置带有标签的商品作为EAS系统的一部分。
当门洞超过2米(72英寸)时,要安装额外的EAS系统天线,以在门洞的宽度上形成额外的通道。
模型 | R506 |
頻率 | 8.2Mhz/10.2Mhz |
工作模式 | TX+RX |
工作电压 | AC(50-60hz)110-220V |
材料 | Aluminem Alloy |
Appearance Size | 1580*380*30mm |
包装 | 2pcs/ctn |
Ctn Size | 1610*420*195mm |
G.W | 15kgs/ctn |
Detection range | 0.9-2M(Depend on tag) |
Function | Install on the shop/market exit door to alarm toAnti-theft |
Product Function:
-
Using advanced digital technology to perform signal processing,which is stong anti-interference.
-
Modulating frequency to transmitter and receiver correspondingly ,which strengthened the anti-interference ability to stagger the frequency in the complex environment.
-
Increase sensitivity automatically adjust function,No need debug.
-
Increase still tag exclude function.When there is still have some tag inside the detect area,the antenna will exclude this signal;then other tags pass the area ,the antenna still work properly..
-
Increase the power protection function,if you made mistake when you connect the power’s positive and negative,will not cause any damage to the motherboard and power,power error indication red light, Re properly connect the power supply will be able to work properly.
This product Installed at the shop exit door to Anti-theft,usually it’s detecting range can reach to:
- 1. Soft Label: 0.8m-1.2m
- 2. Small Tags: 1.2m-1.6m
- 3. Big Hard Tags: 1.5m-2.2m
微信
用微信扫描二维码