EAS Pull Box PB02

• Working voltage: 3V
• Ambient humidity: <80%
• Environment temperature: -10 centigrade C~60 centigrade C
• Alarm sound: 85DB
• Wire rope: 1.2 bags of plastic steel wire
• Extension length: 120CM

Not only has wonderful display effect, but also can avoid theft & damage.

How to use a tablet security display hook?

The EAS pull box has two sets of detection alarms, namely the cut wire rope alarm and the host tilt alarm.
When the alarm condition needs to be turned off, press the remote control on the host and press the OFF button to lift the alarm.
No operation for 180 seconds automatically turns off the warning tone.
If the wire rope is not damaged, pressing the switch at the bottom of the mainframe will automatically enter the defense state.
The micro power circuit is designed to last 2 years with no alarm. When the battery is quickly exhausted, it will be “beep” warning sound within 60 seconds. After the battery is exhausted, the product only wire rope pulling anti-theft function. No electronic audible warning function.

• 1. Peel off the 3M adhesive film at the bottom of the mainframe, and paste it to the appropriate display position. (Figure.1)
• 2. Lock the two screws as needed. (Figure.2)
• 3. Turn the magnetic latch (need to buy again) to the side of the lock, open the lock pin, and then remove the pin. (Figure.3)
• 4. Pull the wire rope, find the host power switch hole from the side, use the pin to align the power switch hole with the host wheel, and insert the host power switch (the power switch cannot be closed properly after opening). The host will sound a beep. (Figure.4)
• 5. A simple screwdriver is included to adjust the size of the wire ring to the correct size. (Figure.5)
• 6. Put the monitor into the wire ring and insert the pin into the lock button to complete the installation. (Figure.6)
• 7. When an alarm occurs, use the remote control (purchased separately) to aim at the top of the main unit and release the warning tone. (Figure.7)