EAS Pull Box PB01

• Working voltage: 3V
• Ambient humidity: <80%
• Environment temperature: -10 °C~60 °C
• Alarm sound: 85DB
• Wire rope: 1.2 bags of plastic steel wire
• Extension length: 90CM or customized

Not only has wonderful display effect, but also can avoid theft & damage.

Features of EAS anti-theft cable box

EAS anti-theft cable box is mainly composed of plastic shell, steel wire rope and clockwork. It is mainly used for anti-theft of commodity display. The product has the characteristics of low cost, easy to use and long service life. The installed cable box does not require maintenance. After the customer experiences the product, the product is automatically retrieved by the cable box, so there is no need to arrange the product manually. Therefore, the cable box has both the characteristics of anti-theft and automatic arrangement and storage.

How to install the EAS anti-theft cable box

• 1. Clean the surface of the cabinet and attach 3M adhesive to the back of the product (or lock it with the screws on the product) tightly to the concealed place on the back of the product cabinet.
• 2. Wire through a certain (hole) position directly pulled to the display product.
• 3. Use 3M adhesive to stick the fastening attachment to the end of the cable puller on the back of the display product.
• 4. Complete the installation.

How to use a tablet security display hook?

The EAS pull box has two sets of detection alarms, namely the cut wire rope alarm and the host tilt alarm.
When the alarm condition needs to be turned off, press the remote control on the host and press the OFF button to lift the alarm.
No operation for 180 seconds automatically turns off the warning tone.
If the wire rope is not damaged, pressing the switch at the bottom of the mainframe will automatically enter the defense state.
The micro power circuit is designed to last 2 years with no alarm. When the battery is quickly exhausted, it will be “beep” warning sound within 60 seconds. After the battery is exhausted, the product only wire rope pulling anti-theft function. No electronic audible warning function.

• 1. Peel off the 3M adhesive film at the bottom of the mainframe, and paste it to the appropriate display position. (Figure.1)
• 2. Lock the two screws as needed. (Figure.2)
• 3. Turn the magnetic latch (need to buy again) to the side of the lock, open the lock pin, and then remove the pin. (Figure.3)
• 4. Pull the wire rope, find the host power switch hole from the side, use the pin to align the power switch hole with the host wheel, and insert the host power switch (the power switch cannot be closed properly after opening). The host will sound a beep. (Figure.4)
• 5. A simple screwdriver is included to adjust the size of the wire ring to the correct size. (Figure.5)
• 6. Put the monitor into the wire ring and insert the pin into the lock button to complete the installation. (Figure.6)
• 7. When an alarm occurs, use the remote control (purchased separately) to aim at the top of the main unit and release the warning tone. (Figure.7)

Packing and Shipping