Transceiver EAS antennas are single antennas that act as both a creator and a receiver of magnetic field input. EAS systems that use transceiver antennas are the least expensive systems. They typically broadcast up to one meter high (with an effective length of 39 inches, one unit can cover a typical door. Two units can easily protect a double door, and if properly spaced, two units can also cover a 4-meter opening in a mall environment. Since the units broadcast and receive, they typically broadcast and receive in all directions, so marked or tagged merchandise cannot be placed too close to the insta built-in antenna. Both RF and AM EAS systems can use transceiver antennas. These are the most popular devices on the market today and come in a variety of shapes, including the popular INEO clear transparent acrylic system, which looks very modern and elegant.
Multi-antenna EAS systems
The most common form of multi-antenna EAS system is the single channel dual antenna EAS system, where more than one antenna is used to form the channel to the store entrance. One of the antennas is the transmitter and the other is the receiver. The antenna generates a low frequency radio wave field between them so that labeled merchandise passes through this field and the antenna senses the tag or label on the merchandise and sounds an alarm. The single channel dual antenna system is used where the store doorway is more than one meter (36 inches) and therefore too wide to use the EAS transceiver system. Since the focus of the radio wave field is between the antennas, this type of EAS system allows for the placement of merchandise with tags or labels within 2 meters (72 inches) as part of the EAS system.
When the door opening exceeds 2 meters (72″), additional EAS system antennas are installed to create additional channels across the width of the door opening.
58khz AM Underground Buried EAS System
AM Underground Buried EAS System
Insurance of main power
Lower than 200W
2 output port
Duration of transmission pulse
1.6ms(conventional peak current is 16.0A)
37.5Hz(50Hz AC),45Hz(60Hz AC)
A brand new intelligent EAS security system of highly value for money. Its design of invisible installation is greatly satisfied with the requirements of open-ended stores.
The induction coil is fully buried under the floor.has no effect with the shop’s environment.with its invisible design and its excellent properties of security at the same time.
Buried underground, no affect to the store’s decoration;
Concealed installation,does not affect the store decoration;
Independent external alarm, can use sound and light alarm;
Advanced selt-detect function, Effectively identify and filter jamming source, zero false positives;
Wide detection range;
Suitable for all the high-end retail malls.
Comment:usually detection height of soft labels is 100cm,maximum detection height of 50mmbar hard tags is 150-180cm.Bury the induction coils under the floor,The invisible induction coils only can be embedded before the ground is floored.
Power requirement of the controller:supply line must be supported by an independent distributor box,please make sure the electric line is grounded properly.when there are 2pieces above of equipments work together,please ensure they share the same circuit.
The master controller should be installed up onto the ceiling.This kind of am system provides a flexible and convenient installation to those stores have no an accessible way to set up a traditional system.Its fully invisible design has no effect to shop’s environment and also has good contribution to enhance the shop’s space.
Buried am system has strict requirements to setting environment,the setting should be prepared before flooring.Please seek for further solution form our marketing staff.
Keep electric cables away from the pedestal, such as power cables, network cables.
The EAS systems must not share a power point with any other equipment.
Do not install EAS system near elevator or electricity box.
Keep metal 2m away from the pedestal. It includes metal shelves, metal racks and foil etc.
Keep product with tag 2m away of the pedestal.
Standard Packing Ways
Packing Gross Weight
3-7Days After Receive
Q: Are you a trade company or manufacturer? A: We are an manufacturer of EAS labels for more than 8 years in Zhejiang, welcome to visit us. Q: What is your MOQ? A: Any quantity is acceptable for your order. And the price is negotiable for large quantity. Q: If samples free? A: Yes, most of samples are free, but not cover freight cost. Q: What is your factory production capacity? A: 700 million pcs labels per year. Q: If I order big quantity, what’s the good price? A: We will refer to the detail item number, quantity, color and quote you our best price. Q: What is the delivery time? A: In gereal, 7-15 days after payment. Q: What about your payment term? A: According to your detail orders, general orders are 100% T/T in advance. Q: Why choose actility? Any advantages? A:
1. Mutual benefit: We are a factory, our price will be cheaper in the same quality.
2. Mix order: We accept mix order, different model and small quantity order.
3. After-sales service : Keep in touch with customer anytime.
Q: How does your factory do about quality control? A: Quality is priority. Our tags/labels are 100% tested and CE certificate is approved.